AIR, LLC offers proven FAA certification, engineering design, modeling, drafting, analysis, and project management experience. Our extensive experience in these areas assures the success of your project.
FAA Continued Operational Safety / FAA Certification / Project Management
- FAA Designated Engineering Representative (DER-T) Services, Part 33 Turbine Engines and APUs
- Post FAA Certification Assistance: Airworthiness Directives (AD), Alternative Methods of Compliance (AMOC) Proposal Preparation
- Perform Part 23 Small Airplane Risk Analysis (SARA)
- Perform Part 25 Transport Airplane Risk Assessment Methodology (TARAM)
- Preparation of Service Information for ADs (FAA Advisory Circular 20-176A)
- FAA Certification Assistance: Parts Manufacturer Approval (PMA), Supplemental Type Certificates (STC), Type Certificates (TC)
- Complex Task Scheduling: Engineering, Design, Analysis, Manufacturing
Engineering Analysis
- Weibull Analysis
- Metallic Structures: Stress Analysis, Thermal Effects
- Mechanisms: Shafts, Splines, Gears, Pulleys, Drive Mechanisms
- Fluid Transfer: Horsepower Requirements, Pump Sizing, Flow Rates & Flow Losses
- ASME Boiler & Pressure Vessel Code
Design and Independent Design Review of the Following:
- Aircraft Turbine Engines and Engine Components
- Aircraft Mechanical Systems
- Turbomachinery
- Mechanisms: Power Transmission, Shafts, Gears, Pulleys, Drive Mechanisms
- Metallic Structures: Structures (Ti, Al, Steel, Ni), Assemblies, Material Selection, Heat Treatment
- Fastening Systems: Threaded Fasteners, Rivets, Pins, Welding
- Investment Castings
- Forgings
- Bearings and Bearing Compartments
- Seals: O-Rings, Carbon Seals, Labyrinth Seals
- Coatings: Corrosion Protection, Thermal Protection
- Oxide Ceramics: High Temperature Heater Core, Thermal Coatings, High Temperature Insulation
- Fluid Transfer: Pumps, Piping, Valves, Oil Supply Systems
Solid Modeling Services (3D CAD)
- Complex 3D Solid Modeling
Drafting Services (ASME Y14.5)
- Detail Drawings
- Manufacturing Drawings
- Assembly Drawings
- Layout Drawings
- Installation Drawings
- Schematic Drawings
- Source Control Drawings
- Interface Control Drawings
Expert Witness Services (Scientific and Technical)
- Accident Investigation
- Failure Investigation
- Expert Engineering Reports
- Forensics
- Depositions and Testimony
- Personal Injury
- Product Liability